Kiln Cooling

Controlled/Slow Cooling

Needs work.

When can I open the kiln?

It’s not unusual to feel impatient while waiting for a kiln to cool! But ideally you should wait until the kiln reaches near room temperature. Otherwise you can try the burning paper test listed below. Your kiln should definitely be below 400F/200C before opening.

Arnold Howard, Paragon Industries, via Clayart:

I feel that you should leave the kiln closed until it reaches room temperature. Ill add, though, that opening the kiln while its still hot wont hurt the kiln. (But it may damage the ware.)

Ivor Lewis via Clayart:

Rapid cooling can damage of some forms of refractory lining shortening the life of your kiln. My suggestion, dont open a kiln until you are sure you can hold the pots in your bare hands, not glove, just with your skin.

Linda Arbuckle via Ceramic Recipes:

Read Frank and Janet Hamer’s book “The Potters Dictionary” on cristobalite. It’s sort of a cousin to quartz alpha-to-beta phase at 1000 degrees. Cristobalite forms from free silica in the body around cone 03, gets 2% bigger, then inverts upon cooling at around the temperature paper burns (Fahrenheit 451 - if anyone remembers the Ray Bradbury story). Actually just a bit lower. The change in size is more abrupt than quartz inversion, and a lot of cristobalite, inverting suddenly and unevenly, can cause dunting. Just a bit is good - puts the glaze under compression and counters crazing. But, the bottom line… if you put paper in the peep and it browns or bursts into flame, you shouldn’t be exposing your work to heat shock yet because you’re above cristobalite inversion. You can also crack work re-firing if you pass through this threshold unevenly. More of a problem for people working at mid-range and highfire than lowfire wares.

Estimating Cooling Time

Andy Rawson via Ceramic Recipes

If you would like a rough estimate of when you can open the kiln you can use this exponential decay calculator.
http://www.miniwebtool.com/exponential-decay-calculator/?n1=532&n2=.18&n3=&n4=200
Put the current temperature of the kiln in the “initial amount”
A decay rate of “.18” works well for most standard electric kilns.
Leave the time empty then put the target opening temperature in the “final amount” field then hit calculate.
Down below it will solve for time in hours to reach the final temperature. Works well for me to tell the wife when we can open the kiln so she stops asking every ten minutes


This text and all user contributions to the Glazy & the Glazy Wiki are licensed under the Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International; additional terms may apply. By using this site, you agree to the Terms of Use and Privacy Policy.
Ceramic Materials Workshop Mighty Mud Mixer Gasworks NYC